Model: Wolli
Suitable for children from 18 months up to max: 5 year
IMPORTANT READ THE INSTRUCTIONS FOR USE CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE
WARNING
WARNINGS BED SAFETY GUARD
- Never leave the child unattended!
- Make sure that the Baby bedguard is never placed close to an open fire or other strong source of heat, e.g. electric radiator, gas cooker.
- The bedguard is not recommended for use by children under the age of 18 months or when the child is over the age of 5 years.
- The bedguard should be used only when the child is able to climb in and out of the bed unaided.
- The bedguard should not be used as a substitute for a cot, as it cannot provide the same level of safety as a cot.
- The maximum thickness of the mattress for which the bedguard is suitable shall be 150 mm.
- The bedguard shall be fitted so that its side, when in the locked position or when placed in fitted position, touches the side of the mattress.
- The bedguard should not be used unless the fixings are in place and securely attached to the mattress.
- The bedguard should be checked to ensure that it is properly fitted and secure once fitted in place.
- The bedguard should be periodically checked for its general condition with particular reference to the security of any locking mechanism or hinges used on the product.
- The bedguard should not be used on a sleeping surface that is more than 600 mm from the floor.
- WARNING: To prevent the risk of strangulation it is essential to ensure that when the bed guard is fitted into position, there is a gap of at least 250 mm (10 in) between each end of the bed and the corresponding end of the bedguard.
- WARNING: Do not use additional and replacement parts other than those approved by the manufacturer or distributor.
CARE AND MAINTENANCE
Please note the textile designation.
Care for, clean and check this product regularly.
Part list
- Upholstery
- Left and right base with belt
- Upper pipes of upholstery
- Bottom pipes of upholstery
Assembly
Assemble the upper and lower upholstery pipes as shown in photo 1.
Insert the upper assembled pipes 3 into the upholstery opening from one end to the other as shown in picture 2.
Connect the pipe with the upholstery to the two pipes on the bases photo 3.
Pull both ends of the upholstery onto the tubes on the bases photo 4.
Insert the bottom tubes 4 into the bottom opening of the upholstery (photo 6) and connect it to the opening of the base.
The bed rail is ready for use photo 6.
- Place the baby bedguard on the bed so that the flat tubes on the base are under the mattress and make sure that the bed rail is firmly in contact with the mattress.
- Position the rope anchor so that it stands perpendicular to the back of the mattress and the mattress frame.
- Tighten the fixed position with the buckle, which is close to the anchor.


