p. 1 in the PDF ↗

i-Size Booster seat
125-150 cm

safety standards (R129/03)

p. 3 in the PDF ↗

Warning

Warning!

In order to provide your child with greatest security, please read this instruction manual carefully:

  • The rigid items and plastic parts of an Enhanced Child Restraint System shall be so located and installed that they are not liable, during everyday use of the vehicle, to become trapped by a movable seat or in a door of the vehicle.
  • Any straps holding the restraint to the vehicle should be tight and adjusted to the child's body, and straps should not be twisted.
  • It is important to ensure that any lap strap is worn low down.
  • The Enhanced Child Restraint System should be replaced when it has been subject to violent stresses in an accident.
  • It is danger to make any alterations or additions to the device without the approval of the Type Approval Authority, and it is also danger not following closely the installation instructions provided by the Enhanced Child Restraint System manufacturer.
p. 4 in the PDF ↗

Be sure that children are not left in their Enhanced Child Restraint System unattended.
Be sure that any luggage or other objects liable to cause injuries in the event of a collision shall be properly secured.

  1. Be sure that the Enhanced Child Restraint System shall not be used without the cover.
    Be sure that the Enhanced Child Restraint System cover should not be replaced with any other than the one recommended by the manufacturer, because the cover constitutes an integral part of the restraint performance.

Product description

TypeStatureFacing directionInstallationApproval type
GRAVO125-150cmForwardVehicle 3point belt + ISOFIX attachmentUniversal booster cushion
Vehicle 3 point belt
p. 5 in the PDF ↗

Notice

Notice

This is a Universal booster cushion Enhanced Child Restraint System. It is approved according to UN Regulation No.129,f or use in i-Size compatible and universal vehicle seating positions as indicated by vehicle manufacturer in the vehicle user's manual.

If in doubt, consult the Enhanced Child Restraint System manufacturer or the retailer.

125- 150cm: ISOFIX connectors+adult safety-belt or adult safety-belt only.

Notice: It is most important that the instruction manual should be retained on the Enhanced Child Restraint System for its life period.

p. 6 in the PDF ↗

Use in the vehicle

WARNING

Never use this child restraint system in seating positions where an active frontal airbag is installed.
An active frontal airbag may cause death or seriously injury of your child in an accident.
Please read the instructions carefully and keep safely for future reference.

You can use your child car seat as follows:

p. 7 in the PDF ↗

Know your car seat

ISOFIX connectors
ISOFIX release button

p. 8 in the PDF ↗

Installation in the vehicle with 3 point belt

Place the child in the universal booster booster seat.

Shoulder belt limit hook must be adjusted so that the shoulder strap is at the same level as your child's shoulder.

Fasten the safety belt buckle until you hear a click. Be sure the safety belt is not twisted and the lap belt shall be worn over the hips.

p. 9 in the PDF ↗

Installation in the vehicle with ISOFIX connectors and 3 point belt

Locate the ISOFIX Anchorage points and place the ISOFIX Sleeve Brackets over the tow points.
Extend the ISOFIX Brackets and connect them to the Anchorage Points of the vehicle.
ISOFIX connector to a suitable position in the. direction shown in the figure.
Ensure that both Indicators tum GREEN!
Ensure that the seat is properly connected by moving it from side to side.

p. 10 in the PDF ↗

Place the child in the universal booster booster seat.

Shoulder belt limit hook must be adjusted so that the shoulder strap is at the same level as your child's shoulder.

Fasten the safety belt buckle until you hear a click. Be sure the safety belt is not twisted and the lap belt shall be worn over the hips.

p. 11 in the PDF ↗

Remove the booster seat

Open the 3-point safety belt from buckle, lead the shoulder and lap belt from the lap belt guide.

Press the ISOFIX release buttons on both sides forward simultaneously, until the indicator in the ISOFIX release button turns to red.

Pull out the booster seat and remove it from vehicle seat.

Press

p. 12 in the PDF ↗

Maintenance

1. Washing

  • The covers can be removed for washing under 30℃ clean water;
  • Clean the shell using a damp cloth.

2. Safety Self-Checking

  • If you have trouble on installation, please contact manufacturer.
  • Checking car belt on time to make sure the safety, once find the broken, please contact manufacturer.

3. Handle after accident

After colliding by accident, please change baby car seat. Or contact manufacturer.